Stitch Holders from Addi, Pony, KA and Clover
Addi Turbo© Circular Stitch Holder
The Addi Turbo© Circular stitch holder allows you to knit off of your work and hold it on the lockable stitch holder, until you are ready to use it again. When you're ready to pick up your project again, simply knit back onto your needles!
Available in: US2, US7 and US10
Turbo Stitchholder #10 (6mm) |
Turbo Stitchholder #7 (4.5mm) |
Turbo Stitchholder #2 (3mm) |
Pony Stich Holders
Pony Stitch Holder - Mini 2" long
|
Pony Stitch Holder - Small 3.25" long
|
Pony Stitch Holder - Medium 4.5" long
|
Pony Stitch Holder - Large 6.5" long
|
Pony Stitch Holder - Jumbo 8" long
|
Clover Stich Holders
3 sizes. Remove either end cap, slip stitches onto the Holder, then replace the end cap.
Clover Double Ended Stitch Holder #351, Set of 2 Size (S) for knitting needles US# 2 -7, Length 5 1/4 inch |
Clover Double Ended Stitch Holder #3006, Set of 2 Size for knitting needles US# 5 -11, Length 5 1/4 inch |
Clover Double Ended Stitch Holder #352, Set of 2 Size for knitting needles US# 5 - 11, Length 6 1/2inch |
Clover Double Ended Stitch Holder #3007, Set of 2 Size for knitting needles US# 11 - 15 , Length 7 7/8 inch. Ultra thick Stitch Holder with removable ends. |
Coilless pin-type Pony Stitch Holder.
1 coiless pin-type stitch. 5.5 inches
For smaller coilless pins, see
Coilless Safety Pins
KA Aluminum Stitch Holders
Set of 2
1 6 inch stitch holder and 1 8 inch stitch holder.
KA coilless pin type stitch holder
1 Metal stitch holder, green. 5.5 inches.
KA coilless pin type stitch holder
1 Metal stitch holder, green. 5.5 inches.